17 Apr
2013
17 Apr
'13
5:34 p.m.
Problem found, thanks to Doru. It was loading the stable version of Glamour. That is
apparently not stable in 4.8. It should load the development version. I changed this, and
now I can continue working once I load GlamourSeaside. Running the tests failed 44 out of
66: When I browse through them I saw two problems: it needed a HTTPRequest, that no longer
exists (problem in Seaside Tests), and I did not start the Parasol server. So no surprises
here yet. Maybe someone else can test if GlamourSeaside loads good?
Cheers,
Diego
P.S. I now loaded my configuration using GTMetaceller.
Thanks for doing this.
I am not sure what you mean by becoming unstable. ConfigurationOfGlamour #development is
already loaded in the image. It should not cause any further problems.
What might happen is that ConfigurationOfGlamour loads Magritte which loads Grease, and
this might have an impact on Seaside. Maybe we are not loading the proper versions. Could
it be it?
Cheers,
Doru
On Wed, Apr 17, 2013 at 4:01 PM, Diego Lont <diego.lont(a)delware.nl> wrote:
Hi all,
Done some more testing and cleaned to configuration to follow standards.
I have an additional note. Currently when I load the development version of
ConfigurationOfGlamour into moose 4.8, my moose becomes unstable. I am not sure what is
wrong here, but this makes it hard to test well. So I guess I am stuck untill Glamour is
stable again in 4.8.
Serge and Doru,
Please let me know if some more work is needed on the ConfigurationOfGlamourSeaside. It
should be fine now.
Cheers,
Diego
Hi all,
I am not fully done testing, but so far looking good, so here I share how far I am:
_______________________________________________
Moose-dev mailing list
Moose-dev(a)iam.unibe.ch
https://www.iam.unibe.ch/mailman/listinfo/moose-dev
--
www.tudorgirba.com
"Every thing has its own flow"
_______________________________________________
Moose-dev mailing list
Moose-dev(a)iam.unibe.ch
https://www.iam.unibe.ch/mailman/listinfo/moose-dev Version 0.4 is tested in Moose 4.8. I loaded it
in Pharo 2.0 and got an error while loading Seaside Tests. Only the tests depend on this
project, so this should be ok. Maybe the tests even run, when you proceed on the warning.
Important note: the configuration of Seaside30 comes from Seaside30 repository instead of
the MetacelloRepository on squeak source. So you need to load this configuration manually
before loading GlamourSeaside.
After manually loading configuration of GlamourSeaside and Seaside30 the following should
load this project:
(ConfigurationOfGlamourSeaside project version: '0.4') load: 'Examples'
After that you should of course start the server by:
ZnZincServerAdaptor startOn: 8080
Cheers
_______________________________________________
Moose-dev mailing list
Moose-dev(a)iam.unibe.ch
https://www.iam.unibe.ch/mailman/listinfo/moose-dev