23 May
2014
23 May
'14
1:02 p.m.
Hi everyone,
we all have seen how cool CodeCity can the visualisation be on example of Pharo3 changes.
But my question is: can we make platform to be somehow wider than the “wall” inside of it?
Because in my case colour of a platform may not be the same as all the nodes on the wall
and it’s hard to understand if it’s the platform that is red or the nodes at the bottom of
the wall.
I’ve tried to do "wallLayout outerGap: 5 asCCPoint”, and it gives the desired result,
but then walls also start to float above platforms.
I’d be thankful for any suggestion.
Uko
23 May
23 May
1:42 p.m.
Hi Uko
5 asCCPoint is equivalent to (CCPoint x: 5 y: 5 z: 5).
As I understand you need to increase the outer gap only along the
horizontal axes (x and z). For this, you can do:
CCPoint x: 5 y: 0 z: 5
or more conveniently:
CCPoint xz: 5 y: 0.
You can also tweak the vertical outer gap by changing y.
Cheers
Ricky
On Fri, May 23, 2014 at 1:02 PM, Yuriy Tymchuk <yuriy.tymchuk(a)me.com> wrote:
Hi everyone,
we all have seen how cool CodeCity can the visualisation be on example of
Pharo3 changes. But my question is: can we make platform to be somehow
wider than the “wall” inside of it? Because in my case colour of a platform
may not be the same as all the nodes on the wall and it’s hard to
understand if it’s the platform that is red or the nodes at the bottom of
the wall.
I’ve tried to do "wallLayout outerGap: 5 asCCPoint”, and it gives the
desired result, but then walls also start to float above platforms.
I’d be thankful for any suggestion.
Uko
_______________________________________________
Moose-dev mailing list
Moose-dev(a)iam.unibe.ch
https://www.iam.unibe.ch/mailman/listinfo/moose-dev
3866
days inactive
3866
days old
1 comments
2 participants
participants (2)
-
Richard Wettel -
Yuriy Tymchuk