EyeSee in squeaksource.

On May 15, 2012 10:16 PM, "Chris Cunningham" <cunningham.cb@gmail.com> wrote:
On Tue, May 15, 2012 at 2:02 AM, Andre Hora <andrehoraa@gmail.com> wrote:
>
> Chris, if you download the last EyeSee the regular axis (#regularAxis) will
> work fine. It automatically creates the steps size, instead of step 1.
> Below you can check the code:
>
> lineBarCompositeDiagram2
>     "self new lineBarCompositeDiagram2"
>
>     | diag1 diag2 diag3 compDiag model1 model2 model3 |
>
>     model1 := #(30 29 25 31 28 24 22 26).
>     model2 := #(14 24 21 11 22 13 43 21).
>     model3 := #(0 20 25 14 18 12 12 15).
>
>     diag1 := (ESDiagramRenderer new lineDiagram)
>         y: #yourself;
>         models: model1;
>         regularAxis;
>
>         defaultColor: Color red;
>         yourself.
>
>     diag2 := (ESDiagramRenderer new lineDiagram)
>         y: #yourself;
>         defaultColor: Color green;
>         models: model2;
>         yourself.
>
>     diag3 := (ESDiagramRenderer new lineDiagram)
>         y: #yourself;
>         defaultColor: Color blue;
>         models: model3;
>         yourself.
>
>     compDiag := ESDiagramRenderer new.
>     (compDiag compositeDiagram)
>         add: diag1;
>         add: diag2;
>         add: diag3;
>         preferredAxisMaxY: 45.
>     ^ compDiag open
>>
>>
>> -Chris
>>
>> _______________________________________________
>> Moose-dev mailing list
>> Moose-dev@iam.unibe.ch
>> https://www.iam.unibe.ch/mailman/listinfo/moose-dev
>
>
>
>
> --
> Andre Hora

Andre,
That does look good.  Which repository is the latest stored in?

-Chris

_______________________________________________
Moose-dev mailing list
Moose-dev@iam.unibe.ch
https://www.iam.unibe.ch/mailman/listinfo/moose-dev